Avoid Geothermal Installation Pitfalls
January 23, 2012The EPA and New Indoor Air Protocol
January 30, 2012
The MERV rating indicates the percentage of particles the air filter will remove from the air passing through it. In general, a MERV rating of 6 indicates that the filter will capture up to half of the particles in the air; a filter with a rating of 8 will trap 70 to 85 percent of air-born particles it encounters; and a rating of 11 or higher means that the air passing through the filter is up to 95 percent cleaner when it comes out of the filter than it was when it went into it [source: Lowe’s].
A properly sized, installed and functioning heating and air system circulates the air in your Hilton Head home every hour. Have your Hilton Head heating and air conditioning contractor perform an inspection to make sure yours is operating at this level. In the process of circulating the air, the system pulls that air through the filter. Just how much the filter cleans the air depends on the MERV rating of the filter. Your indoor air quality is greatly impacted by your air filter.
MERV stands for Minimum Efficiency Reporting Value. MERV ratings indicate the size of particles that a filter can remove from the air passing through it. MERVs range from 1 to 16, with a higher number indicating a higher cleaning efficiency because it can filter smaller particles out of the air. The cheap, 1-inch (2.54-centimeter) thick, disposable filters made of jumbled fiberglass or natural fiber strands typically have a MERV rating of 1 but can go up to 4. Pleated filters made of nonwoven, disposable fabric have smaller pores, and the pleats increase the surface area of the filter so it can hold buy celebrex 200 more particles than a flat surface can. These filters have MERV ratings of 3 and higher depending on the density of the fabric and the number of pleats [source: INDA]. Some are charged with static electricity to attract and hold air-born allergens.
The particle catching efficiency actually goes up as the filter gets dirty; buildup on the fibers shrinks the openings the air passes through and allows the filter to capture more particles. This is good only up to a point. The particle-removing efficiency of the filter is inversely related to the energy efficiency of your heating and air system. A by-product of cleaning the air is a restriction of the air-flow through the system.
Think about times you’ve worn a dust mask while you worked on a project. It’s harder to breathe through the mask than it is if you aren’t wearing one. If you upgrade to the HEPA (high-efficiency particulate air) mask that filters out particles as small as 0.3 microns with up to 97 percent efficiency, it gets even harder to pull in enough air to keep you going [source: Howarth and Reid]. The same is true of your heating and air system. The denser the filter, the harder the system has to work to pull in air. A clogged filter may cause your system to run continuously, driving up your heating or cooling bills. That’s why it’s important to check your filters at least monthly and change them when they get dirty.
Article Source: http://home.howstuffworks.com/home-improvement/heating-and-cooling/air-filters-clean1.htm
